The maintenance of laser marking machine equipment generally includes daily maintenance, regular maintenance, regular mechanical inspection and accuracy inspection. Equipment lubrication and cooling system maintenance is also an important part of equipment maintenance. Today, Xin Quanli Laser will share with you the maintenance of the water circulation cooling system of the laser marking machine.
1. Every time you turn on the machine, check whether there is any looseness in the joints of the waterway and whether there is any water leakage. If there is water leakage, press the emergency stop switch quickly for maintenance.
2. Keep the internal circulating water clean. Observe whether the circulating water has deteriorated every half a month. Change the water periodically according to the water quality and replace the filter element. If the flow of the water pump is too small after the water is changed, this is caused by air congestion in the water pump. Press the red button on the water filter to discharge the air in the water system. After the water flow is normal, the gas mixed in the water will reduce the light transmittance of the water, affect the laser power, reduce the water flow, and the transparent hose. When there are air bubbles in the tank or air bubbles in the water tank return port, check whether the air return pipe is leaking and whether the water level in the water tank is low.
3. Regularly remove the dust from the air filter. When there is too much dust, remove the filter and use an air spray gun, water pipe, etc. to remove the dust from the filter. After the removal is complete, let the filter dry and then reinstall it. Generally 2-4 Clean once a week. If the dirt is serious, use a neutral detergent to clean it irregularly. Regular cleaning of the air filter can extend the life of the chiller and reduce the power consumption of the compressor.
4. Clean the radiator in time according to the concentration of floating dust on the ground. The degree of dust accumulation on the radiator can be easily observed from the air inlet side of the chassis.
The above points are related to the maintenance and maintenance of the laser marking machine water circulation cooling system. As for more corresponding machines, there are corresponding different maintenance points. I hope everyone can maintain the laser marking machine in place. Let the equipment work normally without affecting the daily production marking.